idME PRO (UAS Remote Identification) can be easily connected to Pixhawk controller via JST connector
Sniffer functionality – receive via Bluetooth and WI-FI signal form other RID devices
Increase of broadcast power to +20dBm Wi-Fi and +18dBm BLE
Automatic power adjustment according to the country of use
supports the newest MAVLink protocol, with Open Drone Id Messages
Extended configuration options allow choosing a transmission technology
Its small outline and low power consumption allow to be used in ultra-lightweight drones (20mA)
AT commands provide feasibility to configure broadcast messages, such as drone identification number, type of aircraft, etc. Additional authentication mechanisms are also available.
Our Remote ID module is based on the following technologies:
Wi-Fi (supported NAN and Beacon frames)
BT (supported BLE, and legacy frames)
GNSS (GPS, Glonass, BeiDou, QZSS, Galileo)
Using the BLE and WI-FI broadcast technology, our Remote ID (RID) device provides surveillance and drone operator identification capability based on any modern mobile device such as a smartphone or tablet. Application:
• UAS >250g/open & special category
• U-Space/UTM
• Police/Special forces
• E-identification
