This Remote ID module (RID) is equipped with a high-quality multi-GNSS receiver and a barometric altitude sensor. Thanks to internal GNSS, it becomes an independent device from the autopilot – it only requires a power connection to function.
idME+ (UAS Remote Identification) is designed to meet the requirements of remote drone identification and localization in ASTM/ASD-STAN standards.
Using the BLE broadcast technology, the device provides surveillance and drone operator identification capability based on any modern mobile device such as a smartphone or tablet
idME+ can be easily connected to Pixhawk controller via JST connector
Small outline and low power consumption allow it to be used in ultra-lightweight drones.
AT commands provide feasibility to configure broadcast messages, such as drone identification number, type of aircraft, etc. Additional authentication mechanisms are also available.
Application:
• UAS >250g/open & special category
• U-Space/UTM
• Police/Special forces
• E-identification
